Precast Drainage Channel Moulds

Get the Right Mould for Your Precast Drainage Channel

Send us a channel photo, section or drawing. We will review the mould layout, opening method and practical size range for your production.

U-drains and open channels
Manual, assisted or hydraulic opening
Custom-built from approved drawings

A photo, sketch or early drawing is enough to start.

Custom steel mouldsFor repeat production of precast drainage channels.

Built around your channelSection, length, joints and openings guide the design.

One technical contactFrom drawing review to mould assembly and inspection.

Start with the product

Which channel do you need to produce?

You do not need to know the mould type. Show us the finished channel and we will start from there.

Finished precast U-shaped drainage channel with a rounded internal flow section — **U-drain channels**Rounded or project-defined internal sections for drainage and water conveyance.

Finished precast open drainage channel with outward-sloping side walls — **Open drainage channels**Straight, sloped or project-defined side walls and flow sections.

Have joints, cover seats, outlets or cast-in parts?Include them in the photo or drawing. These details affect the end forms, inserts and release direction.

What should you send?

A photo or sketch is enough to begin

Send what you already have. We will identify the missing details and discuss the next step with you.

1. Product referenceA channel photo, sketch, section or drawing.
2. Main sizeWidth, height, length and wall thickness if known.
3. Production targetExpected output, mould quantity or casting cycle.
4. Special detailsJoints, openings, cover seats or cast-in parts.

We help choose the setup

The mould should fit your production, not just the drawing

Channel size, moving weight, casting frequency and available handling equipment determine how the mould should open.

Steel U-drain mould with its outer side panels opened for demoulding — The opening path must release the concrete without trapping or damaging its edges.

Manual

Simple operator-controlled opening

Considered when panels can be handled safely at the required production rate.

Assisted

Mechanical help for repeated movement

Screw, linkage, rolling or lifting mechanisms can reduce handling effort.

Hydraulic

Controlled movement for heavier parts

Considered when weight, frequency or release requirements justify powered operation.

You do not need to choose now. We recommend a direction after reviewing your channel and factory process.

Why Realjet

One team from drawing review to mould assembly

Your channel geometry, mould functions and production requirements stay connected through the project.

Steel plate cutting at the Realjet manufacturing facility

Review the requirement

We review the channel, size range, output target and factory constraints.

Robotic welding of fabricated steel components at Realjet

Build and assemble

Fabrication, machining and assembly follow the approved mould design.

Dimensional quality inspection of a manufactured steel component at Realjet

Check the agreed scope

Key dimensions, interfaces and final condition are checked before delivery.

What happens next?

Start the discussion without preparing a full specification

We will ask for more detail only when it is needed for the next decision.

01
Send the channel information
A photo, drawing or short message is enough.
02
Review the production route
We discuss size variants, opening, demoulding and output.
03
Confirm the mould scope
Functions and project boundaries are agreed before manufacturing.

Common questions

Before you contact us

Can one mould produce several channel sizes?

Some related lengths or local details may use adjustable ends or replaceable inserts. Large changes in section or release direction may require a different mould.

Can the mould form joints, openings and cover seats?

Yes, these details can be reviewed from the channel drawing. Their position, fixing method and release direction need to be confirmed.

Do I need complete drawings before contacting Realjet?

No. A photo, approximate section, dimensions or an early drawing is enough for the first discussion.

Do you sell finished drainage channels?

No. This page is for steel mould systems used to manufacture precast drainage channels.

Ready to discuss your channel?

Send a Photo. We Will Help With the Next Step.

Tell us what you need to produce. Complete drawings are not required for the first discussion.